Circuit Description
Signal trim circuit will
adjust the output of the load cell with a potentiometer and resistor shunted
across the output of each load cell. Each load cell is isolated from the other
load cells with 1000 ohm series resistors in the signal lines. These isolation
resistors stop the adjustments on one load cell from affecting the other load
cells.
Strain Reliefs
Five, corrosion
resistant, nylon strain relief protect the load cell and instrument cable from
being pulled from the terminals.
Enclosure
NEMA 4 stainless
steel, rust proof, non-corrosive and suitable for use in the harshest environments.
Size
7" W x 4.5"
L x 1.75" H - 2 lbs.
CSB card only - 4" W x 3" L x .75" H - 0.3 lbs
